I took the time to address a minor issue with the tail fairing, where it was trimmed a little too much. Right under the leading edge of the horizontal stabilizer the fairing is designed to cover the gap between two sections of aluminum. I had trimmed it slightly too much and a small 1/8 gap had been created.
I took the fairing home and added some fiberglass and micro-balloons to build up the edge about 1/4 inch. A quick sand and spray with primer and I reinstalled the fairing. I used some more micro balloons behind the fairing, using tape to prevent it sticking to the fuse, and it came out with a perfect fit on the aluminum.
