Today I added a couple more blast tubes to cool the battery, and the voltage regulator on the back of the alternator. I also reconfigured the fuel lines in the engine compartment and moved the fuel flow sensor to the engine mount.
The Earth-X battery gets a lot hotter than the standard battery, and benefits from a blast tube to direct cool air at the battery while in flight. I used a length of 1 inch SCAT tube, some hose clamps, and an aluminum flange to make the blast tube. I used a step drill to upsize the hole to the right size. I also added a lock washer on the back side of the flange, along with RTV to make it secure to the baffling.
I had bought a 3D printed fitting for the back of the alternator that directs air at the voltage regulator, but never installed it. Today I mounted it and hooked it up with a blast tube from the air inlet ramp on the right side of the engine compartment. Lots of RTV, another lock washer, hose clamps, and it was done.
Then I moved onto the fuel lines. I had previously loosened some of the fuel lines to test that my new routing would work. By switching the fuel lines either side of the fuel flow sensor, the sensor moves aft several inches, placing it right above one of the engine mount struts. Today I removed some of the old fittings, added new ones to streamline to fuel line routing, and mounted the red cube to the engine mount. It’ll be much more stable, and cooler, in this location, which should hopefully make for a longer useful life.
